Mini Birdlocked Silicone Male Chastity Device - 40 mm
[XR-AB832-40]

This product is excellent in materials and workmanship, a wonderful product in nearly every way. My wife found it at Cupid's Bedroom. She caught me masturbating a year ago, expressing disgust at that activity, saying that she would not tolerate that ever again on my part. I agreed to quit it, but she caught me again four months ago. She decided to cure the problem herself, finally finding the Mini Birdlocked. All the other devices had a cage that was too long for my tiny cock. All I could fill was two inches or less and the cage of the MB was perfect. She made me order it and it arrived on time, as ordered, without incident. She was pleased with it, but when I tried to put it on, I couldn't. My build is unusual, with my cock being very small, but my balls being a bit larger than normal. I was able to get one ball through the large ring, but I couldn't pull the second one through. Even with my wife pulling, the ring was too tight to get it through. This is an item that you can't return and we didn't want to anyway, as the cage length was just right. My biggest fear was that I'd get it on and then I'd not be able to remove it, especially if my balls swelled at all. We decided to make it work. With no other choice, I cut the large ring halfway between the cage hinge on top and the securing block recess for the ball divider on the bottom. Using a very sharp kitchen slicing knife, I made a clean, perfect cut. My wife applied half a drop of water based lotion to my cock head and it slipped right into the cage, filling it just short of the end. I pulled my balls down and forward, bringing the ends of the large ring together. I put the clear plastic strap which holds the ball divider in place in the first notch. The device was on me, but the ends of the large ring were still apart. Tightening to the second notch did the trick and the ends came together. My cock was in the cage, just about filling it and the large ring was comfortably in place, tightly around my cock and balls. My balls were nicely divided, drawing more attention to them as they were much more in the front. They were nicely displayed, hanging downward, well separated, out to the side and forward. The skin around my balls was tight and my wife was indeed pleased. She feels that my balls are shown off better in this device than any other she has seen. She also likes the division of my balls very much which is unique to this device. Other devices pay attention only to your cock, ignoring your balls. There is a lock that you can put through the pin at the top, but I devised a better attachment especially now that the large ring was cut. I bought large wire ties, ( a plastic tie for electrical cable-you've seen them used as handcuffs in some movies). We threaded it through the securing block at the end of the ball divider and up to the top where we connected the ends. The tie tightens with a ratchet type clip and it cannot be removed after installation. You must cut it off making the lock unnecessary. I can tighten the tie as much as necessary to achieve a tight fit around my cock and balls. If this large ring is not tight, under the pressure of an erection, it will move away from your body and allow your cock to lengthen. She refused to permit any lengthening at all. The silicone that is used in this device is soft and comfortable to wear, with no sharp edges or points of abrasion. My wife lets me have a rest at 24 hour intervals. She makes sure it is on at bedtime and during the day when she works and we are not together. When I try to erect there is absolutely no chance for lengthening. I can feel myself thickening, swelling against the inside of the large ring and the sides and end of the cage. This tightens the large ring even more. The skin on the head of my cock will protrude through the holes close to a quarter of an inch. My wife loves this as she's able to see the frustration she's forcing my little cock to endure. During a futile attempt at erection, when the skin on the head of my cock is protruding through the holes, my pee hole and the skin around it is squeezed tightly into the front hole and my pee hole is squeezed shut. One can still urinate, but it takes a little longer, so be patient. I dry the inside of the hole with toilet paper. The device wears very well under clothes and is perfectly comfortable. With your balls pushed outward, they touch your thighs slightly when you walk, but it is not uncomfortable at all. The alterations we had to make, made adjustment possible in a device where there is no adjustment, as manufactured. If the large ring would have been the larger 45mm size, I might have been able to get my second ball through. The ring may have then been too loose to stay in place and the cage would have been too long for my small cock. All in all this device is great. I could not envision a better one. If you consider buying one, you'll not know of the fit until you try it. If it's too big or too small, you may have to make it work, as we did. If you can achieve a good fit, it'll be worth it.